Alwarerc Senrigan GP-35 Brushless Gimbal For DJI Phantom 1/ User Manual

Senrigan GP-35 Brushless Gimbal Instruction ManualAlexMos Version(1 Mar 2014)Page 1 of 19

Step 17.Stick the BL Gimbal Controller board on the Top Mounting Frame and secure it with 4pcs Nylon M3 Nuts. (Tighten the Nylon Nuts completely.)Step

Step 21.Insert the Motor Cables of Tilt and Roll Motors into the Connector Cases included. Pay attention to the position of each color of wires.Step 2

5. Assembly Steps – IMU MountingStep 1.Prepare the IMU Unit.Step 2.Connect one end of the IMU Cable onto the IMU port of the Gimbal Controller Board.S

Step 5.Front view of GP-35 assembly.Step 5.Side view of GP-35 assembly.Page 13 of 19

6. Assembly Steps – Power Connection and Manually TiltingStep 1.Take off the Top cover of your Phantom. Please refer to the manual of DJI Phantom.Make

Step 5.Insert 1-wire End connector of the into the casing of the Phantom.Step 6.Insert the 1-wire End connector into F2 port of NAZA controller in the

7. Assembly Steps – Setup Manual Tilting on NAZAStep 1.Turn on the Transmitter and then power on the Phantom. Then connect Phantom to the computer wit

Step 5.You will use the additional Channel on the back of Phantom's transmitter to control the Tilt Axis of GP-35 Gimbal. You can use or DIY a fl

8. Power On StepsBefore Power On the Gimbal:1. Please check the polarity of the JST connectors.2. Make sure the IMU is installed on top of the Upper C

9. Alexmos Control Board Connection and TuningUpdated Wiring Diagram for Alexmos Controller BoardSpecification for the Simple Brushless Gimbal Control

Contents1. Introduction:...

Page 20 of 19

10. TroubleshootingQ1: Why does the gimbal not stabilize the camera?A: Please refer to installation and make sure the IMU Unit is installed at right o

1. Introduction:Brushless Gimbal is the next generation technology for high quality aerial photography. Senrigan GP-35 Brushless Gimbal is driven dire

2. Check ListPlease Check the Follow parts.BL Gimbal Controller with Top Mounting Frame1pcsIMU Unit with Soft IMU Cable1pcsNew BL Gimbal Motor 22082pc

Silver Hex Cap Screw M2.5x6mm4 pcsSilver Philip Screw – 2pcsNylon M3 Nut – 4pcsScrew Pack:M2.5x6mm Hex Cap Screw – 8pcsBlack Philip Screw – 2pcsM3 Se

4. Assembly Steps – Mechanism PartsStep 1.Recognize the oriantation for the BL Gimbal Motor.Step 2.Install a Motor Mount onto the Front Side of BL Gim

Step 5.Install the Front Arm onto the Back Side of BL Gimbal Motor using M2.5x6mm Hex Cap Screws which is included with the motor. (Apply little amoun

Step 9.Install the Lower Damper Plate onto the Rear Arm using Black Philip Screws. Pay attention to the installation direction of the Lower Damper Pla

Step 13.Insert 6pcs Rubber Tension Damper Balls into the holes of Top Mounting Frame.Step 14.Complete assembly.Step 15.Install the Top Mounting Frame